STM Oil Pan Drain Plug with 1/8" NPT Temp Sensor Provision (M14x1.5) Select::Plug Only Don't forget your nuts

Don't forget your nuts

8 x peak/hold injector drivers (can be used as low side drive outputs)

Much stronger than the stock gasket and can usually be re-used

Vehicle Fitment: 1996-2001 Evolution IV V VI • Fits with Garrett Gen 2 V-Band • Fits with Garrett/TiAL V-Band • Fits with PTE V-Band • Flanged for TiAL 44mm MVR Wastegate • You will need a custom lower intercooler pipe • You must remove your A/C • You will need a Small Radiator Features: • Hand Fabricated • Tig Welded • Back Purged • Flanged for TiAL 44mm MVR Wastegate • Mild Steel Head Flange to Prevent Pulling Out Studs • Schedule 10 1

STM Oil Pan Drain Plug with 1/8" NPT Temp Sensor Provision (M14x1.5) Select::Plug Only Don't forget your nutsThe STM M14x1. 5 engine oil pan drain plug is machined with an 1 8" NPT temperature sensor provision to allow you to install a temp sensor right into your drain plug. The plug itself has a M14x1. 5 thread which fits most Mitsubishi including DSM, Evo and 3S and some Honda, Acura and Mazda models including Integra, RSX, S2000, Prelude, Civic and RX 7. The drilled inside thread is for an 1 8" NPT sensor. OEM Mitsubishi replacement crush washer gasket is